This is a library of perfboard and single-sided PCB effect layouts for guitar and bass. I'm not an electrical engineer by any stretch of the imagination, just a DIY'er who likes drawing layouts. It is meant for the hobbyist (so commercial use of any of these layout is not allowed without permission) and as a way to give back to the online DIY community.

Monday, July 10, 2017

AMZ Son of Screamer

Where would DIY pedal building be without Jack Orman? Got a request for his Son of Screamer, which is a pretty standard Tube Screamer but with the input and output buffers removed. Pots are board mounted and I added a extra diode in the feedback loop for asymmetrical clipping if you want to go that route. Original schematic and article can be found here.


If you want to have symmetrical clipping, populate the diodes like this:

7 comments:

  1. If I wanted to make a switch for symmetrical/asymmetrical, could I just connect pads E2/E3 to the lugs of a SPST switch? That would effectively remove the third diode from the circuit right?

    ReplyDelete
  2. a question (sorry for my bad english) what ts is this 8 o 9?
    thanks!

    ReplyDelete
    Replies
    1. Neither. The differences between the 808 and the 9 are in the output buffer (which has been removed here).

      Delete
  3. Symmetrical clipping sounds best to my ear, and also replace 220nF with 100nF for a brighter tone. Simple yet great sounded OD. Awesome!

    ReplyDelete